fbpx

Bosma XC FAQ

To restart the XC, simply unplug the camera from power, and plug it in again.

Please make sure that your XC is powered. Remove the white cap of the XC by slightly turning it clockwise. You should then see a white RESET button. Long-press the button until you hear “system reset”. After about 30 seconds, the XC should power up again and you should hear “system startup” and “waiting for connection”. You can now set up the XC in the app again.

Please make sure that you heard “system reset” after long-pressing the reset button, and that you heard “system startup” and “waiting for connection” later. If one of these messages was not heard, please contact customer support.

(1) Download the “Bosma” app, create a new account or log in.

(2) Power on the XC. Wait till you hear “system startup” and “waiting for connection”. If you don’t hear these messages, reset the camera.

(3) On the app home screen, tap the “+” button at the top right corner, and select “XC Series”. Then follow the in-app instructions to complete the setup

If you have any issue during the setup process, please contact customer support.

(1) Steady Red: Powering up or waiting to be set up. If you have not set up the XC before, please set up the XC in the app. If you have set up the XC before but just restarted it, please wait for about 30 seconds and it should automatically reconnect to the existing WiFi.

(2) Steady Blue: Connected. Everything is fine.

(3) Flashing Blue: Reconnecting to an existing WiFi hotspot. This may happen when you have set up the XC but it can no longer find the WiFi hotspot (either because the WiFi name/password was changed, or the camera/router was moved to another location so the signal was lost)

(4) Slow Flashing Red: Cannot connect to server. Please contact customer support.

Remove the white cap of the XC by slightly turning it clockwise. You should see the micro SD card slot located near the reset button. Push the SD card all the way in until you hear that it clicks into place. To remove the SD card, push the SD card in again and it should be ejected from the slot.

(1) Download the latest firmware for XC | XC Connect

(2) Unzip the files and copy the 5 files to the root folder of a micro SD card

(3) Insert the micro SD card into the XC (where is the SD card slot?), and restart the camera

(4) Wait for about 2 minutes. When you hear “system startup” and “waiting for connection” at the end, the firmware update is successful.

(5) Please remember to unmount the SD card and delete the 5 files before using it on the XC. Otherwise the XC will enter firmware update every time it restarts

(1) On the QR code scan page, please have the camera scan the QR code on your phone. Make sure that you have heard the camera say “WiFi is connecting” before tapping the “I heard ‘Wi-Fi is connecting’” button

(2) Please make sure that the WiFi hotspot you selected is 2.4Ghz (5Ghz WiFi is not supported).

(3) Please make sure that the WiFi hotspot uses WPA or WPA2 security

(4) Please double check and make sure that the password is correct

If the issue persist, please contact customer support

Can’t find an answer to your question?

Submit your question below and we will answer it and add it to the FAQ!

Question:

What is your question?

FAQ Author:

What name should be displayed with your FAQ?

Menu